| (Click images below for larger view and light description) |
|
Best Data CMX300
(Click image for front/rear, LED's & larger view)
Click here for LED description
DOCSIS compliant
Modem status-UNKNOWN
|
Cable Modem Information
Model #: CMX300
Connection: Ethernet and USB.
HFC MAC ID Location: Back
HTML Interface: No
Cable Modem Downloads
Installation PDF
Cable Modem HTML Interface
No
Cable Modem Notes;
None at this time.
Best Data Product Support website |
Best Data CMX110
(Click image for front/rear, LED's & larger view)
Read below for LED definitions
DOCSIS compliant
Modem status-UNKNOWN
|
Cable Modem Information
Model #: CMX110
Connection: Ethernet.
HFC MAC ID Location: Back
HTML Interface: Dont think so!..NAH
Cable Modem Downloads
Installation PDF
NA
Cable Modem Notes;
Was not able to obtain alot of info on this Modem.
However since the Modem I believe is discontinued,
I wouldnt worry about it.
Best Data Product Support website |
Cable Modem NOTES:
The 3Com CMX does not have a diagnostics web page, but does have a serial communication port on which it produces a log. To read this log, connect your PC's serial port to the CMX's serial port with a null modem cable (or laplink cable). Launch a terminal emulator such as Hyperterminal, and set the serial communication parameters to 38400 bps, 8 data bits, No parity, 1 stop bit. (You might need to experiment to find the correct flow-control settings to avoid data over-run and a corrupt log view). Power the CMX off and on again, and watch the log stream by as it configures itself. The information in the log includes the signal levels, as described above. The log is produced only during the boot process, and when the CMX is recovering from errors.
|
|
| |
| Light sequence descriptions below -CMX110 |
Function | Definition | ACTION To Be Taken | Power | · Dark for power off · Solid for power on | · Test the outlet for presence of Electricity · NO ACTION NEEDED | Cable | · Dark for no downstream RF carrier present or power off · Flashing slowly for downstream RF carrier present and ranging in progress · Flashing fast for registration in progress · Solid for the Cable Modem registered and ready to transfer data | · Check the coaxial cable properly installed, check for TV reception and if the TV splitter properly installed. You may call your Cable Company for help if you don’t have TV reception. · If flashing does not stop please call your cable company first. The cable network may not recognize your modem MAC ID. In this case please call your cable service provider. | PC | · Dark for no Ethernet carrier present or power off · Solid for Ethernet carrier present | · Make sure your PC is ON and in working condition. Verify if your network card installed properly. Usually a light on the network card indicates it’s working status. Consult with your Network card manufacturer or Best Data technical support for help | Data | · Dark for no user data going through the Cable Modem or power off · Flashing for user data going through the Cable Modem | · If the above 3 LEDs are lit but don’t see this LED flashing, please verify that you have properly installed a TCP/IP drivers. Go back to the installation section. | Test | · Dark for initial self-test of the Cable Modem OK or power off · Flashing for initial self-test of the Cable Modem in progress or software down loading of the Cable Modem in progress · Solid for self-test failure of the Cable Modem | · If the above 3 LEDs are lit but don’t see this LED flashing, please verify that you have properly installed a TCP/IP drivers. Go back to the installation section. |
|
| |
